Bowers & Wilkins ISW-3 Mode D'emploi page 13

Place the subwoofer on the bottom shelf. Unscrew
the feet as required to align the cowl extension vent
with the cut-out in the toekick panel. Keeping the
feet still, screw the locknuts up to the subwoofer
cabinet to maintain position (Figure 44).
Strip the ends of the cable and connect it to the
spring terminals, observing the correct polarity. Then
secure the cable to the cowl using the cable tie to
prevent rattles (Figure 45).
If desired, paint the louvre fascia moulding.
Attach the louvre to the front of the opening and
secure it to the louvre frame using the two M3
machine screws (item 11) through the two bars.
Do not over-tighten.There should be slight bending
tension in the two louvre bars, but the surround
should not be distorted or the fascia will not fit
correctly.
Clip the fascia to the louvre (Figure 46).
Figure 44
h
Figure 45
c
i
i x 2
b
Figure 46
+
13