Bowers & Wilkins ISW-3 Mode D'emploi page 10

Remove the backing paper and apply the two self-
adhesive gasket strips (f), one to the support bar
and one to the cabinet at the other side of the louvre
frame. These will bear on the floor boarding to avoid
rattles (Figure 34).
Bring the subwoofer close to its intended position.
Strip the ends of the cable and connect it to the
spring terminals, observing the correct polarity. Then
secure the cable to the cowl using the cable tie to
prevent rattles (Figure 35).
Place the subwoofer in position, with the brackets
resting in the rebates, and secure it to the joists by
screwing through the support brackets (screws not
supplied) (Figure 36).
f
Figure 34
h
+
Figure 35
Figure 36
f
f
10