Temperature Measurement; Revolution Counter Use - tecnotest STARGAS Manuel D'utilisation

STARGAS ____________________________________________________________________________________ USE
3.2 -

Temperature Measurement

During the carrying out of the tests the engine temperature is displayed on
the TEMP. °C box, after beeing measured through the probe the analyser is
equipped with.
The temperature measuring range ranges between 5 °C and 200 °C.
5 °C are the lowest threshold in compliance with the minimum ambient
temperature at which the instrument must be able to work in temperature.
The temperature probe has to be introduced at the place of the oil dipstick.
In order to introduce it deeply enough, adjust the rubber plug (79) by using
as a reference the original dipstick length.
ATTENTION:
When introducing the temperature probe, do not bring the
connecting cable near sources of strong interferences (coil, spark
plug cables, distributor). Moreover do not twist the cables inside
the engine compartment.
3.3 -

Revolution counter use

While carrying out the gas analysis test, it is also necessary to make sure that
the VEHICLE IS IDLING and at ACCELERATED SPEED (manufacturer's data).
To measure the rpm you can use the internal revolution counter of the tool
that processes a signal from the battery positive terminal and detects the
rpm. That is set for 4-cylinder engines, but also 1, 2, 3, 5, 6, 8, 10, 12
cylinder can be set.
Connect cables as follows:
•
Connect the RPM cable from battery (80) to the battery positive pole.
•
Connect the ground cable (78) to the vehicle chassis.
•
Start the engine, the RPM case on the LCD will read the rpm.
OPERATING INSTRUCTIONS 17