Amann Girrbach Ceramill sintron Instructions D'utilisation page 30

A P P L I C A T I O N
E N
Faulty sintering results!
▷ To ensure proper sintering results, pay attention to the correct
arrangement of the sintering aids. Please also refer to the
Ceramill Argotherm Operating Instructions.
▷ Perform the final sintering of the frames in the Ceramill Argotherm.
▪ Program duration: approx. 5 hours
▷ Upon completion of the program, remove the sintering aids using
pliers.
Faulty sintering results!
▷ Normally, the sintered bridges have a silver colour. When the
frame or certain areas show signs of oxidation, select the sintering
result using the document for evaluation of the sintering results
(see Ceramill M-Center homepage, protected download area).
Post-processing
Post-processing fully anatomical dentures
After the final sintering has taken place:
▷ Thoroughly blast off the frame with a fine-blasting unit using pure
110 – 250 μm aluminium oxide at a pressure of 3 - 4 bar.
▷ If required, rework/adapt the frame using a cross-toothed carbide
cutter.
30
NOTE:
NOTE: