JB Systems Super Led Rainbow Mode D'emploi page 6

ENGLISH
DMX Address
Used to set the starting address in a DMX setup.
 Press the MENU button until "Addr" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to change the DMX address.
 Once the correct address is shown on the display, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
Press the MENU button for about 2 seconds to exit the menu and to go back to the normal running mode.
Channel Mode
Used to set the desired channel
setup mode.
 Press the MENU button until
"ChMd" is shown
display.
 Press the ENTER button, the
display starts blinking.
 Use DOWN and UP buttons to
choose 1MSL, 1Ch, 8Ch or
28Ch.
 Once the desired channel setup
mode shows on the display,
press the ENTER button to
save it.
To go back to the main menu
without any change press the
MENU button shortly.
Press the MENU button for about
2 seconds to exit the menu and to
go back to the normal running
mode.
Slave Mode
Used to set the projector as
master or as slave unit.
 Press the MENU button until
"SLMd" is shown on the display.
 Press the ENTER button, the
display starts blinking.
 Use DOWN and UP button to
select "MASt" (master mode),
SL 1 (normal slave mode) or SL
2 (2 light show) mode.
 Once the mode is selected,
press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
Press the MENU button for about 2 seconds to exit the menu and to go back to the normal running mode.
Show Mode
Used to choose the Show mode when used in standalone or master/slave mode.
 Press the MENU button until "ShMd" is showing on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select one of the 8 available shows: show1 (Sh 1) to show8 (Sh 8)
 Once the right mode shows on the display, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button shortly.
Press the MENU button for about 2 seconds to exit the menu and to go back to the normal running mode.
JB SYSTEMS
®
on the
4/61
OPERATION MANUAL
SUPER LED RAINBOW