Panasonic EY7440 Instructions D'utilisation page 11

7. If the power lamp does not light imme-
diately after the charger is plugged in,
or if after the standard charging time the
charging lamp does not flash quickly in
green, consult an authorized dealer.
8. If a fully charged battery pack is
inserted into the charger again, the
charging lamp lights up. After sever-
al minutes, the charging lamp may
flash quickly to indicate the charging
is completed.
Ni-MH/Ni-Cd Battery Pack
NOTE:
When you charge the battery pack
for the first time, or after prolonged
storage, charge it for about 4
hours to bring the battery up to full
capacity.
Battery charger (EY0L80)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the
plug is inserted into the AC power
supply, but this is not a problem in
terms of safety.
. Insert the battery pack firmly into the
charger.
3. During charging, the charging lamp
will be lit.
When charging is completed, an inter-
nal electronic switch will automatically
be triggered to prevent overcharging.
• Charging will not start if the battery
pack is warm (for example, immedi-
ately after heavy-duty operation).
The orange standby lamp will be
flashing until the battery cools down.
Charging will then begin automati-
cally.
4. When charging is completed, the
charging lamp will start flashing quickly
in green color.
5. If the charging lamp does not light imme-
diately after the charger is plugged in,
or if after the standard charging time the
charging lamp does not flash quickly in
green, consult an authorized dealer.
6. If a fully charged battery pack is
inserted into the charger again, the
charging lamp lights up. After sever-
al minutes, the charging lamp may
flash quickly to indicate the charging
is completed.
- 11 -