Panasonic EY7440 Instructions D'utilisation page 9

• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
This product has the built-in LED light.
This product is classified into "Class 1
LED Product" to EN 6085-1.
Class 1 LED Product
Caution : DO NOT STARE INTO BEAM.
(2) Overheat warning lamp
Off Flashing: Overheat
(normal
Indicates operation has
operation)
been halted due to battery
overheating.
The overheating protection feature
halts driver operation to protect the
battery pack in the event of over-
heating. The overheat warning lamp
on the control panel flashes when
this feature is active.
• If the overheating protection feature
activates, allow the driver to cool
thoroughly (at least 30 minutes).
The driver is ready for use when the
overheat warning lamp goes out.
• Avoid using the driver in a way that
causes the overheating protection
feature to activate repeatedly.
(3) Battery low warning lamp
Off
(normal
operation)
Excessive (complete) discharging of
lithium ion batteries shortens their
service life dramatically. The driver
includes a battery protection feature
d e s i g n e d t o p r e v e n t e x c e s s i v e
discharging of the battery pack.
Flashing
(No charge)
Battery protection
feature active
• The battery protection feature acti-
vates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
• If you notice the battery low warning
lamp flashing, charge the battery
pack immediately.
[Battery Pack]
For Appropriate Use of Bat-
tery pack
Li-ion Battery pack (EY9L40)
• For optimum battery life, store the
Li-ion battery pack following use with-
out charging it.
• The ambient temperature range is
between 0°C (3°F) and 40°C (104°F).
If the battery pack is used when the bat-
tery temperature is below 0°C (3°F),
the tool may fail to function properly.
• When battery pack is not in use,
keep it away from other metal objects
like: paper clips, coins, keys, nails,
screws, or other small metal objects
that can make a connection from one
terminal to another.
Shorting the battery terminals togeth-
er may cause sparks, burns or a fire.
• When operating the battery pack,
make sure the work place is well ven-
tilated.
• When the battery pack is removed
from the main body of the tool, replace
the battery pack cover immediately in
order to prevent dust or dirt from con-
taminating the battery terminals and
causing a short circuit.
- 9 -