General Instructions - T&S B-2346 SINK FAUCET Instructions D'installation Et D'entretien

General Instructions

Installation: Nozzle
Note: Nozzle should be installed first.
See diagram below:
1. Place no.14 over no.11. Make sure
no.12 is in place. Insert no.13 into
side of no.14. Do not tighten.
2. Apply teflon tape or pipe joint
compound to threaded end of no.29.
Screw no.29 into no.14, rotate so that
no.29 is facing front, tighten no.13.
14
11, 12
Installation: Faucet
3. Shut off water supply and drain
lines. Drill (4) four holes (3 holes for
B-2346), into countertop where you
are installing no.1.
faucet body
8"
4"
1-1/4 Ø
1" Ø
4. Place no.1 into the (3) three pre-
drilled mounting holes.
1,4
8
9
10
5. Reinstall no.8, no.9 and no.10 onto
29
no.7 under bottom of sink. Connect
water supply to each no.7.
13
6. Tighten no.10 with a wrench.
Spray Hose/Diverter Installa-
tion:
7. Disassemble no.36 into two pieces,
place no.36 into hole, reattach bottom
half of no.36 to first half. Tighten by
hand under bottom of sink.
8. Apply teflon tape to end of no.35.
Place no.35 through no.36.
9. To attach no.35 to no.1, screw no.6
into no.35, then attach no.6 to no.1.
4" Min.
for hose
1
& spray
1-9/16" Ø
10. Turn on water supply and check
for leaks.
water water
7
supply supply
34,35
sink
36
6
35
sink