General Instructions - T&S B-0679 Mode D'emploi

General Instructions

.
Faucet Installation
:
1. Shut off water supply and drain lines. Drill a 7/8" [2.2 cm] hole in wall or
backsplash of sink where you are installing no.1.
Apply teflon tape or pipe joint compound to threads of water supply lines.
2. Attach no.2 to supply lines flush against wall. Tighten by hand. Trim supply
lines if necessary.
Note: If you are repairing or replacing parts use these instructions:
1. Apply Loctite #680 to threads of no.3, no.4, no.6, and no.8.
2. Insert and thread no.3 into no.2. Thread one end of no.4 into no.3, the other
end into no.5, follow the same procedure for no.6. Remember to apply Loctite
on each end of no.4 and no.6, then rotate no.5 until tight and facing side of sink.
3. Turn on water supply and check for leaks.
1 4
8
Front View
Mounting Hose Hook:
1. Position no.13 against wall. Mark
holes and secure no.13 to wall using
no.12.
2. Attach no.14 (hose end) to
12, 13
threads of no.8.
w a l l
5
8"
20cm
2
water
Side View
supply
l i n e
4