T&S B-2346 SINK FAUCET Instructions D'installation Et D'entretien

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Limited One Year Warranty
T&S warrants to the original purchaser (other than
for purposes of resale) that such product is free from
defects in material and workmanship for a period of
one (1) year from the date of purchase. During this
one-year warranty period, if the product is found to
be defective, T&S shall, at its options, repair and/
or replace it. To obtain warranty service, products
must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other transpor-
tation charges of the product to T&S and the return
of repaired or replaced product to the purchaser are
the responsibility of the purchaser. Repair and/or
replacement shall be made within a reasonable time
after receipt by T&S of the returned product. This
warranty does not cover Items which have received
secondary finishing or have been altered or modi-
fied after purchase, or for defects caused by physi-
cal abuse to or misuse of the product, or shipment
of the products.
Any express warranty not provided herein, and
any remedy for Breach of Contract which might arise,
is hereby excluded and disclaimed. Any implied
warranties of merchantability or fitness for a particu-
lar purpose are limited to one year in duration. Under
no circumstances shall T&S be liable for loss of
use or any special consequential costs, expenses
or damages.
Some states do not allow limitations on how long
and implied warranty lasts or the exclusion or limi-
tation of incidental or consequential damages, so
the above limitations or exclusions may not apply
to you. Specific rights under this warranty and other
rights vary from state to state.
P/N: 098-009431-45 Rev.1
Date: 980508
Drawn: CW
Checked:
MW 6-10-98
Approved:
MAB 6-10-98
Installation and
Maintenance
Instructions
B-2346 SINK FAUCET
(with diverter, vacuum
breaker, stainless steel
hose and spray)
Deutsch:
Installations- und
Wartungsanleitungen
Español:
la Instalación y las
Instrucciones de
Mantenimiento
Français:
les Instructions
d'Installation et
d'Entretien

Publicité

Table des Matières
loading

Sommaire des Matières pour T&S B-2346 SINK FAUCET

  • Page 1 T&S of the returned product. This warranty does not cover Items which have received secondary finishing or have been altered or modi- B-2346 SINK FAUCET fied after purchase, or for defects caused by physi- cal abuse to or misuse of the product, or shipment of the products.
  • Page 2: Exploded View

    Exploded View Some items are listed for instructional purposes and may not be sold as separate parts.
  • Page 3 Part Number Guide Base Faucet Assemblies Body, Faucet Seat 000763-20 Valve, Diverter Piston 002338-45 Escutcheon, Body 001259-40 Locknut, Cover Plate 000712-25 Adapter, 1/8 MA x 3/8 NPSM Shank, Faucet Washer, Rosette 001000-45 Washer, Shank 000999-45 Locknut, 1/2 NPSM Shank 001801-20 Adapter, Diverter 001484-20 O-Ring, Center Body...
  • Page 4: General Instructions

    General Instructions Installation: Nozzle Note: Nozzle should be installed first. See diagram below: 1. Place no.14 over no.11. Make sure no.12 is in place. Insert no.13 into side of no.14. Do not tighten. sink 2. Apply teflon tape or pipe joint compound to threaded end of no.29.
  • Page 5: Instrucciones Generales

    Instrucciones Generales Instalación: Boquilla Nota: Las boquillas deben de ser instaladas primero. Mire el dibujo de abajo: 1. Coloque la parte No.14 sobre la Lavatorio parte No.11. Asegúrese que la parte No.12 esté bien situada. Insarte la Lineas de parte No.13 entre el lado de la parte surido No.14.
  • Page 6: Instructions Générales

    Instructions Générales L’Installation De L’Ajutage: Noter: L’ajutage devoir être installer au début. Voir le diagramme ci- dessous: 1. Mettre Nº.14 sur Nº.11. Soyez certain que Nº.12 être à sa place. l’évier Insérer Nº.13 dans le côté de Nº.14. Ne le resserrer pas. les tuyaux qui fournir les tuyaux...
  • Page 7: Allgemeine Anleitungen

    Allgemeine Anleitungen Schwenkhahninstallation: Anmerkung: Den Schwenkhahn als erstes installieren: 1. Nr.14 auf Nr.11 aufsetzen. Sicherstellen, daß Nr.12 Spültisch ordnungsgemäß installiert ist. Nr.13 seitlich in Nr.14 einfügen. Nicht anziehen. Wasserleitung 2. Teflonband oder Rohrdichtmasse Wasserleitung auf das Gewinde von Nr.29 auftragen. 5.
  • Page 8 RELATED T&S BRASS PRODUCT LINE B-2347 Lavatory Faucet with Hose Spray T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’ Phone: (864) 834-4102 Oude Nieuwveenseweg 84...

Table des Matières