T&S PRE-RINSE UNIT B-0133 Instructions D'installation Et D'entretien

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Limited One Year Warranty
T&S warrants to the original purchaser (other
than for purposes of resale) that such product is
free from defects in material and workmanship
for a period of one (1) year from the date of pur-
chase. During this one-year warranty period, if
the product is found to be defective, T&S shall,
at its options, repair and/or replace it. To obtain
warranty service, products must be returned to...
T&S Brass and Bronze Works, Inc.
Attn: Warranty Repair Department
2 Saddleback Cove
Travelers Rest, SC 29690
Shipping, freight, insurance, and other trans-
portation charges of the product to T&S and the
return of repaired or replaced product to the pur-
chaser are the responsibility of the purchaser.
Repair and/or replacement shall be made within
a reasonable time after receipt by T&S of the
returned product. This warranty does not cover
Items which have received secondary finishing
or have been altered or modified after purchase,
or for defects caused by physical abuse to or
misuse of the product, or shipment of the prod-
ucts.
Any express warranty not provided herein,
and any remedy for Breach of Contract which
might arise, is hereby excluded and disclaimed.
Any implied warranties of merchantability or fit-
ness for a particular purpose are limited to one
year in duration. Under no circumstances shall
T&S be liable for loss of use or any special con-
sequential costs, expenses or damages.
Some states do not allow limitations on how
long and implied warranty lasts or the exclusion
or limitation of incidental or consequential dam-
ages, so the above limitations or exclusions may
not apply to you. Specific rights under this war-
ranty and other rights vary from state to state.
P/N:
098-012286-45 Rev.1
Date:
990322
Drawn:
CW
Checked:
MAB 4/5/99
Approved:
MW 4/6/99
Installation and
Maintenance
Instructions
PRE-RINSE UNIT
B-0133
Deutsch:
Installations- und
Wartungsanleitungen
Español:
la Instalación y las
Instrucciones de
Mantenimiento
Français:
les Instructions
d'Installation et
d'Entretien

Publicité

Table des Matières
loading

Sommaire des Matières pour T&S PRE-RINSE UNIT B-0133

  • Page 1 Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of pur- chase.
  • Page 2: Exploded View

    Exploded View Side View Some items are listed for instructional purposes and may not be sold as separate parts.
  • Page 3 Part Number Guide Body Faucet Assemblies Asm, Faucet (Rigid) 002832-40 Faucet Body (Rigid) Washer 001019-45 Asm, Coupling Flange 002893-40 Asm, Cartridge LH, w/Spring Checks 002711-40 RH, w/Spring Checks 002712-40 Handle, Lever - Hot 001637-45 Handle, Lever - Cold 001636-45 Index, Button Body, Swivel Unit 3/8 ‘O’-Ring Hot (Red)
  • Page 4: General Instructions

    General Instructions Faucet Installation: 2. Slide no.15 down no.14 (about halfway) and tighten temporarily. 1. Shut off water supply and drain lines. Drill (2) two holes, approximately 3. Screw no.13 1-1/4” diameter in wall where you are down on no.14 installing no.1.
  • Page 5: Instrucciones Generales

    Instrucciones Generales 2. Deslice la parte No.15 en la parte No.14 Instalación de la canilla: (a cerca de medio trayecto) y apriete 1. Cierre la fuente principal de agua y temporalmente. desagüe las tuberías. Perfore (2) dos huecos 3. Atornille la parte apróximadamente de 3 cm de diámetro en la No.13 sobre la parte pared donde será...
  • Page 6: Instructions Générales

    Instructions Générales 2. Faire glisser N°.15 sur N°.14 L’Installation Du Robinet: (à mi-chemin) et resserrer temporairement. 1. Fermer la réserve de l’eau et égoutter la tuyauterie. Percer deux (2) trous avec un 3. Visser Nº.13 sur diamètre environs 3 cm dans le mur avec les Nº.14 et resserrer par le centres de 20 cm où...
  • Page 7: Allgemeine Anleitungen

    Allgemeine Anleitungen Installation des Mischhahns: 2. Nr. 15 an Nr. 14 herunterschieben 1. Wasserzufuhr abdrehen, und Rohre (ungefähr halbwegs) und dann dort leerlaufen lassen. Zwei (2) Löcher mit einem vorläufig festziehen. Durchmesser von ungefähr 3 cm in die 3. Schrauben Sie Nr. 13 Wand, an die Nr.
  • Page 8 RELATED T&S BRASS PRODUCT LINE B-0100 PRE-RINSE UNIT W/ FLEXIBLE S-STEEL HOSE B-0113 PRE-RINSE B-2223 PRE-RINSE B-20K PARTS KIT T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, T & S Brass-Europe Travelers Rest, SC 29690 ‘De Veenhoeve’...

Table des Matières