General Instructions - T&S B-2250 Instructions D'installation Et D'entretien

General Instructions

Installation:
See separate instructions for installing
no.7 into deck.
1. Shut off water supply and drain
lines. Apply tefl on tape or pipe joint
compound to threads on both ends of
no.5. Screw no.5 into no.7 and hand
tighten.
2. Slide no.6 down no.5 (about half-
way) and tighten temporarily.
6
5
3. Screw no.4 down on no.5 and hand
tighten, then tighten no.4 with a wrench,
which will also tighten no.5. Make sure
to align no.3 with no.2 over center of
sink, directly in front of no.5 while
tightening.
Note: If new no.3 is being installed
on no.2, make sure it's installed in the
upright position.
4
4. Adjust position of no.6 so that no.1
hangs loosely in it without straining
no.2 or no.3.
7
5. Turn on water supply and check for
leaks.
See back pages for similar unit
installations.
7
4
3
2
1
Caution: Turn off water supply
at base faucet when not in use.