Engine On/Off Switch - Ribimex Ribiland PRBVB196TH Manuel D'instructions Et D'utilisation

1. ENGINE ON/OFF SWITCH

- Move the engine on/off switch to
the ON position.
4.9.2- Stopping the Engine
a. Move the throttle lever fully
right towards the
4.9.3- Engine EMERGENCY Stop
Emergency Stop
If the engine is stopped using the emergency stop button (6), reset the button by
rotating it right until it pops up.
The button must be reset to start the engine
2. FUEL - Move the fuel lever to
the right, OPEN position.
3. CHOKE - Move the choke lever
to the left, choke (closed) start
position.
Note: If the engine is still hot,
closing the choke is not necessary.
4. THROTTLE - Move the throttle
lever slightly left towards the
symbol
b. move the engine on/off switch to
the OFF position,
indicator,
.
5. STARTER - Grip the recoil
starter and slowly pull until
resistance is felt, then pull the
recoil starter rapidly.
Allow the rope to rewind slowly
and if necessary, repeat this
procedure until the engine starts.
6. Once started move the choke
lever right (run) position and open
the throttle lever further left - run
at full speed.
c. and fuel lever left, closed
position.
Page 35 / 45