Disclaimer; Safety Notes - Chauvet DJ KINTA FX Mode D'emploi

Disclaimer

Chauvet believes that the information contained in this manual is accurate in all respects.
However, Chauvet assumes no responsibility and specifically disclaims any and all liability to
any party for any loss, damage or disruption caused by any errors or omissions in this
document, whether such errors or omissions result from negligence, accident or any other
cause. Chauvet reserves the right to revise the content of this document without any obligation
to notify any person or company of such revision, however, Chauvet has no obligation to
make, and does not commit to make, any such revisions. Download the latest version from
www.chauvetlighting.com.
The works of authorship contained in this manual, including, but not limited to, all design, text
and images are owned by Chauvet.
© Copyright 2020 Chauvet & Sons, LLC. All rights reserved.
Electronically published by Chauvet in the United States of America.
CHAUVET, the Chauvet logo and "Kinta FX" are registered trademarks or trademarks of
Chauvet & Sons, LLC. (d/b/a Chauvet and Chauvet Lighting) in the United States and other
countries. Other company and product names and logos referred to herein may be trademarks
of their respective companies.

Safety Notes

The Safety Notes include important laser system safety information. Read and understand all
instructions before powering on the laser for the first time. Knowing these safety instructions is
crucial to avoiding laser eye injury and breaking the law. Keep this User Manual in a safe place
for future reference.
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
Page 8 of 120
STOP AND READ ALL LASER SAFETY DATA
Lasers can be hazardous and have unique safety considerations. Permanent eye injury and
blindness are possible if lasers are used incorrectly. Pay close attention to each safety
REMARK and WARNING statement in this User Manual. Read all instructions carefully
BEFORE operating this device.
Always connect the product to a grounded circuit to avoid the risk of electrocution.
Always disconnect the product from the power source before cleaning.
Avoid direct eye exposure to the light source while the product is on.
Make sure the power cord is not crimped or damaged.
Never disconnect the product from power by pulling or tugging on the cord.
If mounting the product overhead, always secure to a fastening device using a safety cable.
Make sure there are no flammable materials close to the product when operating.
Do not touch the product's housing when operating because it may be very hot.
This product is not intended for permanent installation.
Always make sure that the voltage of the outlet to which you are connecting the product is
within the range stated on the decal or rear panel of the product.
The product is for indoor use only! (IP20) To prevent risk of fire or shock, do not expose the
product to rain or moisture.
Always install the product in a location with adequate ventilation, at least 20 in (50 cm) from
adjacent surfaces.
Be sure that no ventilation slots on the product's housing are blocked.
Never connect the product to a dimmer.
Always use the mounting bracket to carry the product.
Do not switch the product on/off in short intervals. This will reduce the laser diode life.
Do not shake this product. Avoid brute force when mounting or operating this product.
ALWAYS use a safety cable when mounting the product overhead.
The ambient operating temperature for the laser is 59 °F to 95 °F (15 °C to 35 °C). Do not
operate this product outside this range.
In the event of a serious operating problem, stop using the product immediately.
Kinta FX User Manual Rev. 2