Cleaning, Storage, Disposal - Beurer medical FT 60 Mode D'emploi

error
message Problem
Ambient temperature below 10 °C or above 40 °C
(<50 °F, >104 °F).
Device no longer functioning correctly.
(1) Forehead thermometer mode: the tempera-
ture measured is higher than 42.2 °C (108 °F).
(2) SCAN mode: the temper ature measured is
higher than 80 °C (176 °F).
(1) Forehead thermometer mode: the tempera-
ture measured is lower than 34 °C (93.2 °F).
(2) SCAN mode: the temperature measured is
lower than -22 °C (-7.6 °F).
Autotest not successful.

8. cleaning, storage, disposal

Clean the sensor tip after every use. Use a clean cloth or cotton bud that can be moistened with disinfectant, alcohol or
warm water.
To clean the entire device, use a soft cloth slightly moistened with a mild soapy solution. Water must never get into the
device. If water gets into the device, remove the battery immediately. Only use the device again when it is completely dry.
Do not use any harsh cleaning agents.
Never immerse the device in water.
Always store the thermometer with the cap on in order to protect the sensor.
Solution
The ambient temperature must be between 10 °C and 40 °C
(50 °F, 104 °F).
Take out battery for approx. 1 minute and insert again. If the
error message is repeated, consult your dealer or customer
service.
Operate the thermometer only between the specified tempera-
ture ranges. If necessary, clean the sensor tip. In the event of
a repeated error message, contact your dealer or customer
service.
Operate the thermometer only between the specified tempera-
ture ranges. If necessary, clean the sensor tip. In the event of
a repeated error message, contact your dealer or customer
service.
Insert new battery.
17