Beurer medical FT 60 Mode D'emploi page 14

The thermometer also offers additional functionalities:
– 9 memory locations for simple plotting of changes in temperature,
– date and time, also with all stored temperatures measured,
– Optical and acoustic fever alarm at temperatures over 37.5 °C,
– switchable to °C and °F.
5. Operation
Remove the protective cap and switch on the thermometer with the " " button. After a short self-test
and two short beep tones, the thermometer is ready for forehead temperature measurement.
5.1 Setting time and date
With the thermometer switched on, hold the " " button depressed for 5 seconds. As soon as the "SET" symbol appears
in the display, you can use the "SCAN" button to set in turn the 12 or 24 hour mode, hour, minute, year, month and day
(‚24' appears in the display for the 24-hour mode). Confi rm the values set in each case with the " " button.
5.2 Batteries
The Type 3V CR2032 battery is already fi tted and depending on usage has a life of around 3000
measurements. When the battery gets weak, the battery warning symbol appears . It is still pos-
sible to measure the temperature. Battery must be replaced. When the battery symbol fl ashes ,
the battery must be exchanged by sliding the battery compartment cover off to the rear.
Switch off the device, press the batttery compartment lock with a sharp object and slide the battery
compartment cover downwards at the same time.
Insert a new battery of the same type with the positive pole at the top. Close the battery compart-
ment cover again.
Used batteries should not go into domestic refuse. You are legally obliged to dispose of the batteries cor-
rectly. Dispose of them through your electrical dealer or local recycling centre.
Note: you will fi nd these symbols on batteries containing toxic substances: Pb = battery contains lead,
Cd = battery contains cadmium, Hg = battery contains mercury. The battery in this device does not contain Pb Cd Hg
toxic substances.
14