Zone Parameters; Incidences - Airzone FLEXA 3.0 IBPRO6 Guide D'installation

ZONE PARAMETERS


Associated outputs. It displays and allows you to select the control outputs associated with the thermostat.

Thermostat settings. Use this parameter to define the thermostat as Master or Zone.
ES
*Note: It cannot be configured as Master if there is already another Master thermostat.

Use mode. The thermostats can be set in Basic or Advanced mode. They are set in Advanced mode by default. These
are the parameters you can control in basic mode: On/off, set-point temperature and fan speed.
EN
If you need to reset the thermostat to Advanced mode, access the advanced configuration menu and then activate
the advanced use mode.
FR

Control stages. This parameter is used to configure both cooling and heating stages in a single zone or in all the
zones. These are the features to be configured:
IT
- Air: It activates the heating/cooling air in the zone.
PT
- Radiant (only in heating stages): It activates the radiant heating in the zone.
- Combined (only in heating stages): It activates the heating air and radiant heating in the zone and lets the user
DE
choose which heating stage to use: Air, Radiant or Combined. The zone will start using the heating air stage. Once
the room temperature reaches the differential preestablished (see parameter Hysteresis Configuration), the zone
will activate the radiant stage.
- Off: It deactivates the cooling/heating stage in the zone.

Offset. Correction of the ambient temperature in the different areas of the system mode in both cold and heat.

Reset thermostat. It resets the thermostat and returns it to factory values.

INCIDENCES

If an error message is shown, you can check both the Installation Manual and the Self-diagnosis section. Please visit Myzone
web: myzone.airzone.es/productos/
26