Bosch GDE18V-1 Manuel D'utilisation Et Consignes De Sécurité page 6

160992A2L3 GDE18V-16.qxp_GDE18V-16 5/8/17 10:29 AM Page 6
Inserting/Removing Drill Bits (Fig. 3)
- Press and hold the button 4 and pull the
guide 3 all the way outward.
- Release the button 4.
- Slide the tip of the drill bit through the dust
cap 1 from behind (A) and then fit the bit
into the chuck according to the
instructions of your power tool (B).
- Before removing the drill bit, press the
button 4 again and pull the guide 3 all the
way outward.
Adjusting the Guide Length (Fig. 4)
To ensure that dust is extracted cleanly and
the depth stop is set correctly, the guide 4
must be adjusted so that the tip of the drill bit
is flush at the front with the dust cap 1.
- Press and hold (A) the button 4 and move
(B) the guide 3 until the tip of the drill bit is
flush with the "crosshair" of the dust cap
1.
- Release the button 4.
Note: To store the dust
extraction attachment,
press the button 4 and pull
the guide 3 all the way
outward. This relieves
strain on the guide's
spring, which increases
the lifetime of the spring.
Adjusting the Drilling Depth (Fig. 5)
The button 2 for depth stop adjustment can be
used to set the required drilling depth X.
– Press and hold the button 2 and slide it along
the guide 3 so that the distance X shown in the
illustration matches your required drilling depth.
– When the desired distance X is reached,
release the button 2.
6
FIG. 3
FIG. 4
1
1
1
FIG. 5
A
1
B
3
1
B
3
3
2
4
A
4
x