Window Installation Kit - INVENTOR CLCO290-09 Manuel D'utilisateur

|Installation
Part Description
Unit Adaptor
Exhaust Hose
*
Window Slider Adaptor
*
*
Wall Exhaust Adaptor A
* *
(only for wall installation)
* Wall Exhaust Adaptor B
(with cap) (only for wall
*
* installation)
Screw and anchor
*
*
(only for wall installation)
* Window Slider A
* Window Slider B

Window Installation Kit

Step One: Preparation of the Exhaust Pipe
Apply pressure to the exhaust pipe and the window
adaptor one side, and the unit adaptor on the other, attach
with the use of the elastic buckles located on the adaptors.
Step Two: Install the Exhaust hose assembly to the unit
Attach the exhaust hose in the air outlet of the unit with the
use of the arrows.
Step Three: Preparing the Adjustable Window Slider
1. Depending on the window size, make necessary
adjustments on the window slider.
2. If the length of the window requires two window sliders,
use the bolt to fasten the window sliders once they are
adjusted to the proper length.
3. For some models, if the length of the window requires
three window sliders(optional), use two bolts to fasten the
window sliders once they are adjusted to proper length.
12
Europe
Quantity Part
*
1 pc *
*
1 pc
1 pc
*
1 pc
*
*
1 pc
*
4 set
1 pc
NOTE: Items with * are optional. Slight
1 pc
variations in design may occur.
Description
Bolt
Security Bracket and Screw
*
Drain Hose
* Foam Seal C (Non-adhesive)
* Foam Seal A (Adhesive)
Foam Seal B (Adhesive)
Remote Controller
Exhaust hose
Press into Press into
Unit adaptor Window slider
adaptor
Window slider A
Bolts
Window slider A Window slider B Window slider C
Quantity
1 pc
1 set
1 pc
1 pc
2 pc
2 pc
1 pc
Exhaust hose
assembly
Bolt
Window slider B
EN