NEC MultiSync A500 Manuel D'utilisation page 14

On-Screen Manager (OSM )
To attach the MultiSync A
instructions:
1. Turn off the power to your computer and MultiSync monitor.
2. If necessary, install the display card. For more information,
refer to the display card manual.
3. For the PC: Connect the MultiSync A
video cable to the display card's connector on the computer.
Tighten screws on all connectors.
For the Mac: Connect the MultiSync Macintosh Cable
Adapter to the monitor's connector on your computer.
Connect the MultiSync A
the other end of the cable adapter. Tighten screws on all
connectors.
4. Connect one end of the power cable to the MultiSync
A /A
500
5. Turn on your MultiSync monitor and computer.
6. This completes the installation.
NOTE: If you have any problems, please refer to the
Troubleshooting section of this manual.
On-Screen Manager (OSM )
Now, On-Screen Manager (OSM ) Controls have made the MultiSync
monitor's Advanced Digital Control System easier to use by providing
menus on screen. A touch of the up front controls turns on OSM,
allowing you to easily navigate through menus and adjust controls.
OSM allows you to control the Brightness, Contrast, Size, Position,
Geometry and other OSM Utilities. User adjustments are saved
automatically when you change menus. Controls can be reset to factory
settings by pressing the reset button.
/A
500 700
monitor and the other end to the power outlet.
700
monitor to your system, follow these
500
/A monitor's signal cable to
500 700
E - 9
/A monitor's
700