Burg Wächter secuENTRY 5670 BRIDGE Mode D'emploi page 7

5. Open the App Store on your
smartphone and search for
"secuENTRY KeyApp" to
download the app.
6. Open the App and register.
Select the option to create
a Cloud account.
7. Choose "No account yet?
Create one."
8. Enter a password and click
"GET VERIFICATION CODE."
9. You will receive an e-mail
with the code at the e-mail
address you entered.
10. Enter this code into the app
and press "REGISTER."
Now you can add your
device to the KeyApp.
11. Press the back button.
12. Press the menu button
and select "secuENTRY
Bridge."
13. Press "secuENTRY Bridge
and Assignment."
14. Add a Bridge by pressing
the "+" button.
15. Enter the name of the
Bridge and the password for
your WLAN network.
Attention: your
smartphone and your
Bridge must
be located in the same
2.4GHz network!
16. Press "CONFIGURATION."
English I 12
Now your Bridge will connect to
your WLAN network and your
Burg-Wächter Bridge Cloud
account. The various features of
the secuENTRY 5670 BRIDGE
are explained in detail in the
KeyApp instructions.
Firmware update
via Bluetooth
Firmware updates can only be
installed via Bluetooth at this
time.
To install an update, proceed
through the following steps:
1. Unplug the device's USB cable
and wait ten seconds.
2. Use a thin object to press the
reset button
USB cable back in.
3. Hold down the reset button
until both LEDs flash
simultaneously.
4. The secuENTRY 5670
BRIDGE is now ready to
receive firmware updates for
the next two minutes.
and plug the
English I 13