Mounting & Removing Blanks; Mounting Discs In The Working Chamber - VHF K5+ Mode D'emploi

K5+ – Operation: Preparing jobs
6.4 Mounting & removing blanks
The machine can process the following blanks:
Discs with a diameter of 98.5 mm – 98.8 mm
n
Blocks, max. size: 45 x 20 x 20 mm (L/D/H)
n
Prefabricated abutments
n
requires extra equipment
*
You can obtain extra equipment from customer
service.
How to mount the different blank types
Holder
Blank type
required?
Discs No
Blocks Yes
Prefabricated Yes
abutments
6.4.1 Mounting discs in the w orking cham-
ber
1. Open the working chamber door.
2. Unlock the blank holder by pulling the left and / or
right blank holder lever (marked orange in the fig-
ure) towards yourself into the end position.
The blank holder cover moves upwards and the
blank holder is open.
F . 34 O
IG PENING THE BLANK HOLDER
3. Remove the blank from the blank holder if any.
4. To insert the disc to be processed, do the fol-
lowing:
*
*
How to mount
Discs >> Blank holder
Blocks >> Block holder >>
Blank holder
Prefabricated abutments
>> Prefabricated abut-
ment holder >> Blank
holder
Original Operating Instructions: K5+
Version: 12/16/2021
a. If the blank is a multilayer blank, orientate the
blank so that the top color layer is on top.
b. If the disc has been processed before, ensure
the following:
The original top side faces upwards.
n
If the disc has been marked for safer
n
remounting by DENTALCNC, ensure
that the marking is in the position
shown below.
c. Put the disc into the blank holder.
F . 35 I
IG NSERTING A DISC INTO THE BLANK HOLDER
)
SAFE REMOUNTING MARKED BLUE
EN 31
(
POSITION FOR