Installing Hepa/Activated Carbon Filter - Aerus Pure&Dry Mode D'emploi

INSTALLING HEPA/ACTIVATED CARBON FILTER

CAUTION:
Disconnect power before changing filter.
You have the ability to filter and purify air with your Pure & Dry dehumidifier by using the HEPA/
Activated Carbon Filter. Activated Carbon Filters can effectively remove VOCs, dust, smoke and
odors from the air. HEPA filters effectively remove dust and allergens.
Once the unit reads that the filter has been installed, the Air Purification Mode will light up and the
interior fan will begin to run at high speed. You can control the speed of the fan by selecting the
Humidity Set Key
The unit will not operate if a filter is not detected in Air Purification Mode. The filter light will flash,
indicating that a filter needs to be installed.
NOTE:
Depending upon usage and environment, we recommend you change the HEPA/
Activated Carbon Filter each season but no less than once every 8 months. The unit will
keep track of how many days your filter has been working. When the filter is replaced,
press the FILTER TIMER to reset.
1. Open front panel and remove the
washable Pre-Filter by unsnapping from
its notches.
2. Place the HEPA/Activated Carbon Filter
into the plastic frame. Place the washable
Pre-Filter back over the HEPA/Activated
Carbon Filter and snap back into place.
3. Close front panel. Insert tabs at bottom
into base and push closed at top. It is held
into place by magnets.
%
. This will allow you to choose between High and Low wind speed.
M
9