Water Removal - Aerus Pure&Dry Mode D'emploi

WATER REMOVAL

WARNING: To avoid electric shock, disconnect power before removing collected water.
There are two ways to remove collected water: Manual Drainage or Automatic Drainage
MANUAL DRAINAGE
• When the water bucket is full, the FULL BUCKET indicator light will flash,
and the unit will beep for 10 seconds
• Slowly pull the bucket out of the unit (see image)
• Carefully remove the top of the water bucket and dispose water
• Replace the top of the water bucket and slide back into the unit
NOTE: The water bucket must be securely reinstalled for the unit to
operate. Make sure the lid is firmly fastened and the floating ball
is able to move. It is recommended to turn off and wait several
minutes for residual condensate and fully drain into the bucket.
AUTOMATIC DRAINAGE
Water can automatically be emptied into a floor drain by connecting the included Drainage Hose.
NOTE: This option will require the unit to drain via a gravity system. Failure to properly place the
unit and install the hose may result in water leakage. Please read instructions thoroughly.
Once installed, we recommend monitoring the Pure & Dry unit to ensure the unit is
draining properly.
Step One: Find the drainage port on the side of the dehumidifier, as shown in the figure.
Step Two:
Insert a screwdriver into the circular groove, pry off the ribs connected
with the body, and take out carefully.
Step Three: Take out the water tank and push aside the
water outlet pressure plate.
Step Four: Connect the Drainage Hose with suitable
length to the drain port (insert about 10 mm).
See following page for more information.
10
Pry Up
Up