Arneg Pelican G3 H205 Manuel D'installation Et D'utilisation page 36

5 Loosen the screws that fix the anti-
fraying fork on the upper part of the
door. Let the fork slide and rotate it as
indicated in figure A:
6 In order to remove the door, it must be
lifted and simultaneously rotated as
indicated in the drawing so that it is
first released from its housing on the
bottom part. Given the weight of the
door the collaboration of two workers
is recommendedl.
N.B.If difficulties are encountered
while removing the door, use a lever in
wood or other similar material so not
to damage the door itself. Delicately lift
the door a few millimetres so as to
withdraw the pin of the lower hinge.
Do not exert unneccessary force
7 Remove the door and place it on a flat
horizontal surface so as to carry out
the inversion operation in the best way
possible. Fully remove the entire lower
hinge unit.
A) Remove the screws (1) and (2)
using the respective spanners
B) Remove the lower hinge uni
C) Withdraw everything, including the
galvanised block
D) Dismantle the galvanised block unit
(3)
E) Remove the elastic ring that holds
the sleeve in place (4) using the appro-
priate pliers
F) Remove the lower pin-guide sleeve
(5)
05060104 01 01/09/2015
A
(2)
D
(3)
A
(1)
A B
E
(4)
Pelican
English
(3)
C
F
(5)
37