Peg-Perego uno Notice D'emploi page 13

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR
FUTURE REFERENCE. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD PUT
THE CHILD'S SAFETY AT RISK.
_ THIS PRODUCT IS DESIGNED FOR A CHILD WHOSE MAXIMUM WEIGHT IS 45
POUNDS (20 KG) AND WHOSE MAXIMUM HEIGHT IS 43 INCHES (110 CM). THIS
SHOPPER BASKET IS DESIGNED TO CARRY A MAXIMUM WEIGHT OF 11 POUNDS (5
KG). ANY CUPHOLDER EVENTUALLY PROVIDED WITH THIS UNIT IS DESIGNED TO
CARRY A MAXIMUM WEIGHT SPECIFIED ON THE CUPHOLDER ITSELF. ANY POACH
OR POCKET PROVIDED WITH THIS UNIT IS DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 0.44 POUNDS (0.2 KG).
_ FAILURE TO FOLLOW MANUFACTURER'S SPECIFICATIONS OR USE OF
ACCESSORIES OTHER THAN THOSE APPROVED BY THE MANUFACTURER MAY
CAUSE THE UNIT TO BECOME UNSTABLE.
_ AVOID SERIOUS INJURY FROM FALLING OR SLIDING OUT. ALWAYS USE COMPLETE
5 POINT SEAT BELT.
_ NEVER LEAVE YOUR CHILD UNATTENDED.
_ ALWAYS USE ALL THE BRAKES WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY, WHEN MAKING ADJUSTMENTS ENSURE THE CHILD'S
BODY IS CLEAR OF ALL MOVING PARTS.
_ ALL OPERATING AND ASSEMBLY PROCEDURES SHOULD BE PERFORMED BY AN
ADULT.
_ DO NOT LIFT THE STROLLER BY GRIPPING THE FRONT BAR. THE FRONT BAR IS
NOT DESIGNED TO WITHSTAND LOADS.
_ ENSURE THAT THE STROLLER IS OPENED CORRECTLY AND LOCKED IN POSITION
OF USE.
_ CHECK TO MAKE SURE THAT THE CAR SEAT OR THE BABY CARRIAGE IS CORRECTLY
FASTENED TO THE STROLLER (WHERE APPLICABLE).
_ DO NOT DRIVE THIS PRODUCT AROUND STAIRS OR STEPS; CARE MUST BE TAKEN
IF UNIT IS USED ON STAIRS OR ESCALATORS.
_ DO NOT USE THE PRODUCT IF IT HAS BROKEN OR MISSING PARTS.
_ DO NOT USE NEAR FIRE OR EXPOSED FLAME.
_ NOTICE: THIS ARTICLE MEETS OR EXCEEDS ALL REQUIREMENTS COVERED IN
ASTM F833 STANDARD AND LATEST REVISIONS.
INSTRUCTIONS
1 OPENING: press both buttons on the handlebar at the same time and lock it in the vertical position (fig_a).
Release the two clips (fig_b), pull the handle up firmly (fig_c) then push it down until it locks into position.
2 FITTING THE WHEELS: Place the large wheels alongside their slots and push them in until they click into place.
3 BASKET: to fit the basket, press the side buttons (fig_a) and pull out the basket ring (fig_b). Check that it is
correctly positioned (fig_c).
4 Slide the ring into the basket fabric (fig_a) and push it into the housing on the stroller until it clicks into
position. Clip the basket onto the buttons on the side (fig_b) and slip the two loops onto the stroller at the
front. (fig_c).
5 The stroller basket has three positions. The normal position can be seen in Figure A. The basket can be
lowered to allow it to be used even when the backrest is completely lowered. By pressing on it, it is easier to