Hilti SCW 22-A Mode D'emploi page 23

2.3 Grips
Grip and auxiliary grip
2.4 Protective device
Blade guard and pivoting guard
2.5 Lubrication
en
Grease lubrication
2.6 Power tool protection against overload and overheating
The power tool is equipped with an electronic protection system to prevent overloading and overheating. The power
tool switches itself off automatically in the event of overloading and overheating. After releasing the on / off switch,
the power tool may not restart immediately when the switch is pressed again (while the power tool is cooling down).
2.7 Lithium‑ion battery charge status
When a lithium-ion battery is used, the charge status can be indicated by gently pressing one of the battery release
buttons (press until resistance is felt - do not release the battery). The display on the rear of the battery provides the
following information:
LEDs light constantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
-
2.8 Items supplied as standard
1 Power tool
1 Saw blade
1 Hexagon socket wrench
1 Operating instructions
1 Hilti toolbox (optional)
1 Cardboard box (optional)
1 Rip fence
1 Connecting piece for sawdust extractor
1 Guide rail adapter (optional)
2.9 Additional items required for operating the tool
One B 22/3.3 Li‑Ion battery or one B 22/2.6 Li‑Ion battery for the SCW 22‑A plus a C4⁄36‑90 or C4⁄36‑350 or C4/36 or
C4/36‑ACS charger.
NOTE
Depending on the version, these items may be supplied with the power tool.
18
LEDs blink
-
-
-
-
LED 1
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %