Hearth And Mantel Clearances - Kozy Heat Fireplaces KZK-1510A Manuel D'installation

3.3 Hearth and Mantel Clearances

The following drawings show the hearth and mantel clearances
allowed for the CLW-50 and BHM-44 with no surround or optional
surrounds installed (if applicable). Follow the drawings for the
minimum distance needed between the hearth and mantel when
installing an optional surround to allow for proper servicing
clearances.
3.3.1 CLW-50 Finishing Guidelines
Surround Edge
Finishing Trim Edge
Figure 3.7, Finishing Guidelines for Optional Surrounds
Figure 3.8, Hearth and Mantel Clearances for No Surround
Komfort Zone Kit #KZK-1510A R.4
B
CLW-50
Non-Combustible Zone
No Surround
Combustible wall nish
may be installed over cement
board and butt up to the nshing
edge around the opening
Steel
Framing
Each square represents
1" (25mm)
of mantel projection
Non-combustible
material
12" (305mm)
9" (229mm)
6" (152mm)
Finishing Edge
¾
16 "
(425mm)
½
26 "
(673mm)
Finishing Edge
6" (152mm)
¾ 9" (229mm)
9 "
(248mm)
12" (305mm)
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
for Optional Surrounds
• Figure 3.7 shows where to end finishing materials, when
measuring from the finishing edge, to allow installation of any
optional surround. Most finishing material will not fit behind the
optional surround(s) when it is installed.
• Measurement 'A' shows the space to leave on each side.
• Measurement 'B' shows the space to leave on the top and the
bottom.
Surround
CW50-RS
CW50-RS4
A
CW50-GS
CW50-FS
½
" (13mm) clearance
around pipe
Fireplace Enclosure Floor
A B
3/4" (19mm) 1-1/2" (38mm)
2-5/8" (66mm) 2-5/8" (66mm)
6" (152mm) 2-1/2" (64mm)
3-1/8" (79mm) 3-1/8" (79mm)
FACING AND FINISHING 19