Changing Ptz Protocol Information; Default Values Of The Dip Switches; Accessing The Dip Switches - Lorex LZC7092B 10X Manuel D'utilisation

7
Changing PTZ Protocol
Information
The camera's PTZ protocol information allows a DVR to communicate with it
and control the camera's movement.
Note
You will not need to change the default protocol information on your camera unless you
are using multiple PTZ cameras or if your DVR does not support the default settings (see
your DVR's instruction manual for details).
PTZ protocol information on this camera is set using DIP switches inside the
camera. DIP switches represent binary values. This means that they are either
On (1) or Off (0).
The DIP switches control 3 values:
1. The ID of the camera, which allows the DVR to identify different PTZ
cameras.
2. The protocol, which is the language that allows the camera and DVR to
speak to each other (e.g. Pelco D).
3. The baud rate, which is the frequency of communications.

7.1 Default values of the DIP switches

• Default ID: 1.
• Default Baud Rate: 9600.
• Default Protocol: Pelco-D.

7.2 Accessing the DIP Switches

1. Rotate the dome cover counterclockwise to remove it from the camera.
2. The DIP switches are located below the camera module.
#LX400006; r. 1.0/11219/11445; en-US
1
2
16