Setting The Camera Protocol And Baud Rate - Lorex LZC7092B 10X Manuel D'utilisation

7
Changing PTZ Protocol Information

7.4 Setting the Camera Protocol and Baud Rate

The protocol is the language that allows the camera and DVR to communi-
cate, and the baud rate is the frequency of signal sent to the camera. The
camera supports Pelco-D and Pelco-P protocols.
Protocol and baud rate are set using switches 1 and 2 on the smaller DIP
switch panel. See the table below.
Protocol and baud rate switches
1
OFF
ON
OFF
ON
Note
Switches 3 and 4 are for manufacturer use only and should always be set to OFF.
#LX400006; r. 1.0/11219/11445; en-US
2
OFF
OFF
ON
ON
Protocol/Baud Rate
Pelco-D 2400
Pelco-D 9600
Pelco-P 4800
Pelco-P 9600
18