Specifications - Panasonic WV-CLR930 Mode D'emploi

Specifications

Power source:
Image sensor:
Effective pixels:
Scanning area:
Scanning system:
Scanning frequency:
Synchronization:
Resolution:
Minimum illumination:
Signal-to-noise ratio:
Video output:
External sync input:
Lens mount:
ALC drive:
External terminal:
Functions:
Camera title:
Light control:
Electronic shutter speed: OFF (1/50), 1/120, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000,
Gain control:
Sensitivity up:
Synchronization:
White balance:
Video motion detection:
Digital noise reduction:
Resolution:
Black-and-white mode:
Privacy zone:
Horizontal flip:
Lens drive:
Image stabilizer:
Back focus:
Special:
WV-CLR930: 220 to 240 V AC, 50 Hz 5.1 W
WV-CLR934: 24 V AC, 50 Hz 4.5 W or 12 V DC 410 mA
1/2-inch type {1/2"} interline transfer CCD
752 (H) x 582 (V)
6.4 mm (H) x 4.8 mm (V)
2 : 1 interlace
Horizontal: 15.625 kHz, Vertical: 50 Hz
Internal (INT), line-lock (LL), external synchronization (VBS/VS),
multiplexed vertical drive (VD2)
Horizontal: 570 TV lines (BW mode), 540 TV lines typ., 520
TV lines (color mode, resolution: HIGH)
Vertical: 400 TV lines (at center)
BW mode: 0.008 lx (F1.4)
Color mode: 0.09 lx (F1.4)
50 dB (AGC Off)
VBS 1.0 V[P-P]/75 Ω, composite signal, BNC connector
VBS/VS 1.0 V[P-P]/75 Ω, composite signal, BNC connector
CS-mount
DC drive/Video drive switchable
Alarm output
(Open collector with max. 16 V DC and 100 mA)
Color/black-and-white selection input (5 V DC pulled up)
RS485 (4-wire/2-wire, termination: switchable)
Up to 16 characters (alphanumeric characters, marks)
ALC/ALC+/ELC
1/10 000
ON (adjustable)/OFF
OFF/X2 AUTO/X4 AUTO/X6 AUTO/X10 AUTO/X16 AUTO/X32
AUTO/X2 FIX/X4 FIX/X6 FIX/X10 FIX/X16 FIX/X32 FIX/X64 FIX/
X128 FIX
INT (internal sync)/VD2/VS*/VBS* (auto swiching)/
LL* (power supply synchronization)
* Phase adjustable
ATW1/ATW2/AWC
MODE1/MODE2/OFF
LOW/MID/HIGH
NORMAL/HIGH
AUTO1/AUTO2/EXT/ON/OFF
ON (1)/ON (2)/OFF
ON/OFF
DC/VIDEO
ON/OFF
ABF (AUTO/PRESET/FIX), MANUAL-ADJ
CHROMA GAIN, AP GAIN, PEDESTAL, PIX OFF
59