Panasonic WV-CLR930 Mode D'emploi page 21

Setting of RS485 terminal switch
For the case below, slide the RS485 terminal switch (function switch No. 2) inside the side
cover rightward to select "RS485 LINE TERM". (Default setting: "RS485 LINE TERM")
• When 1 camera is connected to this unit
• When 2 or more cameras are connected to this unit that works as a termination
For the case other than the above, slide the switch leftward to select "Hi-Z".
Setting of 2-wire/4-wire selection switches
The communication method can be selected with 2-wire/4-wire selection switches (function
switches 3-5). (Default setting: 4-wire communication) The function switches No. 3-5 should
have the same setting.
Right: 2-wire communication
Left: 4-wire communication
21