Panasonic WV-CLR930 Mode D'emploi page 12

x
Connect the ALC connector (accessory) of the lens to the ALC lens connector of
the camera.
If an auto iris lens with a different shaped connector is used, replace the connector with the
ALC connector (accessory).
q Cut off the lens cable from the connector.
w Strip the end 8 mm of the lens cable outside
cover, and then, remove each cover of the
core wires by 6 mm.
e Solder the core wires to the pins of the ALC
connector securely.
Pin 1:
Pin 2:
Pin 3:
Pin 4:
12
ALC lens connector
ALC connector
Red (Power)
Not used
White (Video)
Black (Shield)
Lens cable
Cut here
Lens cable
Approx. 6 mm
Pin 3
Pin 1
Pin 2
ALC connector
Approx. 8 mm
Rib
Pin 4