Functional Description - Milwaukee Radius 2155-AC Manuel De L'utilisateur

GROUNDING
Improperly connecting the ground-
DANGER
ing wire can result in the risk of
electric shock. Check with a qualified electrician if
you are in doubt as to whether the outlet is prop-
erly grounded. Do not modify the plug provided
with the tool. Never remove the grounding prong
from the plug. Do not use the tool if the cord or
plug is damaged. If damaged, have it repaired by a
MILWAUKEE service facility before use. If the plug
will not fit the outlet, have a proper outlet installed
by a qualified electrician.
Double Insulated Tools (Two-Prong Plugs)
Tools marked "Double Insulated" do not require ground-
ing. They have a special double insulation system which
satisfies OSHA requirements and complies with the
applicable standards of Underwriters
Laboratories, Inc., the Canadian Stan-
dard Association and the National Elec-
trical Code. Double Insulated tools may
be used in either of the 120 volt outlets
shown in Figures B and C.
SPECIFICATIONS
Cat. No. .................................................... 2155-AC
AC Input Volts ............................................ 120-277
AC Input Watts ....................................................70
AC Output Volts ......................................... 120-277
Max Terminal Block Ampacity ..............................30
Wiring ....................... Romex and MC, 14-2 to 10-3
Consult with Local and National Electrical Codes

FUNCTIONAL DESCRIPTION

2
1
Fig. B Fig. C
3
4
5
6
1. Wiring Cover
2. Cover screw
3. Cable
4. Wire clamps
5. AC input/output
6. Cable clamp
7. LED cover
7
SYMBOLOGY
Volts
Alternating Current
Electrical Shock Hazard
Read Operator's Manual
CAUTION
Double Insulated
UL Listing for Canada and U.S.
US
C
ASSEMBLY
To reduce the risk of injury, always
WARNING
unplug tool before changing or
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Conversion to Permanent Wiring
WARNING! Always install light in accordance with
local codes.
To add lights in a chain, or replace the wiring:
1. Unplug the light.
2. Open the wiring cover by turning the cover screw
1/4 turn counterclockwise.
3. Remove and discard old wiring.
4. To add wiring, expose 3 to 4 inches of the wires
from the outer jacket/armor.
5. Feed the wire through the AC input/output holes, and
butt the outer jacket/armor up against the wire clamps.
6. Tighten the wire clamps using the clamping screws.
Hand tighten wire clamp screws securely to 8 lb-in.
7. Wire the lamp according to the diagrams below.
Use one side for wiring to the AC plug, and the
other for wiring to another lamp in a chain. Hand
tighten terminal block screws securely to 10 lb-in.
8. Close the wiring cover and secure by turning the
cover screw 1/4 turn clockwise.
Clamping
screws
3
Bright Light -
Do Not Stare Into Light
Wire
AC Input/
clamps
Output Holes
Strain
Relief