Philips HF3507/10 Mode D'emploi page 2

ENGLISH
Introduction
Congratulations on your purchase and welcome to Philips! To fully benefit
from the support that Philips offers, register your product at
.
com/welcome
The Philips Wake-up Light helps you wake up more pleasantly. The
light gently prepares your body for waking up at the set time. To make
waking up an even more pleasant experience, you can use natural wake-
up sounds or the FM radio to wake up to (HF3508, HF3507, HF3506,
HF3505 only).
The effects of the Wake-up Light
The Philips Wake-up Light gently prepares your body for waking up during
the last
30 minutes of sleep. In the early morning hours our eyes are more
sensitive to light than when we are awake. During that period the
relatively low light levels of a simulated natural sunrise prepare our body
for waking up and getting alert. People who use the Wake-up Light wake
up more easily, have a better overall mood in the morning and feel more
energetic. Because the sensitivity to light differs per person, you can set
the light intensity of your Wake-up Light to a level that matches your light
sensitivity for an optimal start of the day. For more information about the
Wake-up Light,
see
www.philips.com.
Important
- Read this important information carefully before you use the
appliance and save it for future reference.
Danger
- Water and electricity are a dangerous combination. Do not use this
appliance in wet surroundings (e.g. in the bathroom or near a shower
or swimming pool).
- Make sure the adapter does not get wet.
- Do not let water run into the appliance or spill water onto the
appliance (Fig. 1).
Warning
- The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug, as this causes a hazardous situation.
- Only use the adapter supplied.
- Do not place anything close to the appliance that could cause water
or any other liquid to drip or splash onto the appliance.
- If the mains cord or the adapter is damaged, always have it replaced
with one of the original type in order to avoid a hazard.
- Do not immerse the appliance in water nor rinse it under the tap.
- This appliance is not intended for use by persons with reduced
physical, sensory or mental capabilities, or lack of experience and
knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their
safety.
- This appliance is for indoor use only (Fig. 2).
- Cords present a potential strangulation hazard. Keep the cord out of
reach of children aged under 3 years.
- Make sure that the cord is secured to the wall and check it regularly.
Wrap up all slack cord between fastener and socket.
- Always keep cords and cables away from babies, children, cots and
playpens.
- This product is not a toy. Children shall not play with the appliance.
- Not suitable for children under 36 months. Small parts, choking
hazard.
- LED light is very bright. Do not stare at the operating light source.
Caution
- The adapter transforms 100-240 Vac, 50/60 Hz to a safe low voltage
of 15 Vdc.
The adapter's maximum input current is 0.15 A, the main unit's
maximum input current is 0.36 A.
- Do not use the adapter in or near wall sockets that contain or have
contained an electric air freshener to prevent irreparable damage to
the adapter.
- Clean the appliance with a dry or damp soft clean cloth only. Do not
use abrasive cleaning agents and pads or cleaning solvents like alcohol,
acetone, etc. , as this may damage the surface of the appliance.
- Do not drop the appliance on the floor, hit it hard or expose it to other
heavy shocks.
- Place the appliance on a stable, level and non-slippery surface.
- Do not use the appliance at room temperatures lower than 10°C or
higher than 35°C.
- Do not impair the cooling of the appliance by covering the appliance
with items such as blankets, curtains, clothes, papers, etc.
- Never use the appliance if the lamp housing is damaged, broken or
missing.
- Consult your doctor before you start using the appliance if you have
suffered from or are suffering from serious depression.
- Do not use this appliance as a means to reduce your hours of sleep. The
purpose of this appliance is to help you wake up more easily. It does not
diminish your need for sleep.
www.philips.
- The appliance has no on/off switch. To disconnect the appliance from
the mains, remove the adapter from the wall socket. The adapter must
remain easily accessible at all times.
- This appliance is only intended for household use, including similar use
for instance in hotels.
General
- This appliance allows you to choose the light intensity level you want to
wake up to.
- Intended to wake you up with gradually increasing light.
- This is not a general illumination product.
- If you often wake up too early or with a headache, reduce the light
intensity level.
- If you share a bedroom with someone else, this person may unintentionally
wake up from the light of the appliance, even though this person is further
removed from the appliance. This phenomenon is the result of differences
in light sensitivity between people.
- The power consumption of the appliance is lowest if the radio (only
for type number HF3505 and higher) and the lamp are switched off.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic fields.
Recycling
- This symbol means that this product shall not be disposed of with
normal household waste (2012/19/EU) (Fig. 3).
- Follow your country's rules for the separate collection of electrical
and electronic products. Correct disposal helps prevent negative
consequences for the environment and human health
Warranty and support
If you need information or support, please visit
or read the separate worldwide guarantee leaflet.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, please visit
frequently asked questions or contact the Consumer Care Centre in your
country.
Problem
The appliance does
not work at all.
The appliance does
not respond when
I try to set different
functions.
The lamp does not
go on when the
alarm goes off.
HF3508, HF3507,
HF3506, HF3505 only:
I do not hear the
alarm sound when
the alarm goes off.
HF3508, HF3507,
HF3506, HF3505 only:
The radio does not
work.
HF3508, HF3507,
HF3506, HF3505 only:
The radio produces a
crackling sound.
The alarm went off
yesterday, but it did
not go off today.
www.philips.com/support
www.philips.com/support
Solution
Perhaps the adapter is not inserted properly in the wall socket.
Put the adapter properly in the wall socket.
Perhaps there is a power failure. Check if the power supply works
by connecting another appliance.
Remove the adapterfrom the wall socket and reinsert it.
The appliance goes back to factory settings. You need to set all
functions again.
Perhaps you set a light intensity level that is too low. Increase the
light intensity level.
Perhaps the appliance is defective. Contact the Philips Consumer
Care Centre in your country.
Perhaps you set a sound level that is too low. To set a higher
sound level, see chapter 'Using the appliance', section 'Radio/
volume'.
Perhaps the radio is not tuned correctly to a channel. Switch on the
radio to check if the radio is tuned correctly to a radio channel.
If you selected the radio as the alarm sound, the radio may be
defective. Switch on the radio after you switch off the alarm to
check if the radio works. If it does not work, contact the Philips
Consumer Care Centre in your country.
The radio may be defective. Contact the Philips Consumer Care
Centre in your country.
Perhaps you set the volume too low. Increase the volume level.
Perhaps the broadcast signal is weak. Adjust the frequency (see
chapter 'Using the appliance' section 'Radio/volume' in the user
manual) and/or change the position of the antenna by moving it
around. Make sure you have unwound the antenna completely.
Perhaps you switched off the alarm function. When the alarm is
switched ON, the alarm icon is shown in the display. If you do not
see the alarm icon on the display, press the alarm button once.
(See chapter 'Using the appliance' section 'Setting the alarm' in the
user manual).
Perhaps you set a sound level and/or light intensity level that is
too low. Set a higher sound and/or light intensity level.
for a list of