Renault Radio Connect R&Go Mode D'emploi page 92

PAIRING AND UNPAIRING A TELEPHONE
After sixty seconds, if pairing fails,
repeat these steps. Please refer to your
telephone's user guide for further infor-
mation.
Pairing a Bluetooth® telephone with
the audio system from your phone
This method allows you to make a
Bluetooth® search from your phone.
To pair your phone using this method,
perform the following steps:
– display the telephone menu by
pressing button 10 on the audio
system front panel, or 16, 21 or 26
on the steering column control;
– depending on the audio system
front panel, select "Pair device" by
turning and pressing the 5 knob or
press the 14 buttons and confirm
with the 25 button, depending on the
steering column control, with the 20
or 23 knob
GB.26
(2/3)
– the message "Please re-enter Pin"
appears on the system screen and a
sixty-second countdown begins.
The audio system is now visible to other
Bluetooth® devices for about a minute.
– Search for the audio system indi-
cated under the name "MY CAR" or
'R&Go Multimédia' using your phone
then select it (refer to the user guide
for your phone).
The message "MY CAR connected" or
"R&Go Multimédia" appears on your
phone to inform you that your audio
system is paired and connected with
your phone.
If pairing fails, the audio system display
returns to the main menu.
For safety reasons, carry
out these operations when
the vehicle is stationary.
If the maximum number of telephones
paired with the audio system is
reached, you need to unpair an exist-
ing telephone before pairing a new one
(refer to the information on "Unpairing a
telephone" in this section).
Your hands-free phone
system is only intended to
facilitate communication by
reducing the risk factors,
without removing them completely.
You must always comply with the
laws of the country in which you are
travelling.