Parts Identification; Safety Devices - Comet KF STEEL Série Notice Technique

Table des Matières

Les langues disponibles

Refer to figures 2, 3, 4 and 5.

1. Main switch

2. Handle

3. Lance rest

4. Warning plates. Inform on residual risks and PPE

to be used

5. Identification plate. Indicates the serial number,

guaranteed sound power value (in compliance

with Directive 2000/14/EC) and main technical

characteristics

6. Electric power cable

7. Fuel tank cap

8. Pressure adjustment knob

9. Water softener tank cap

10. Pressure gauge

11. Swivel wheel brakeSwivel wheel brake

12. Water outlet connector

13. Water inlet connector

14. Exhaust

15. Cleaner gun

16. Lance pipe

17. Nozzle support head

"0" position (off) of main switch (1).

"1" position (on) of main switch (1), with cold water operation of high pressure

cleaner enabled.

"1" position (on) of main switch (1), with hot water operation of high pressure

cleaner enabled. With pressures less than 32 bar/464 psi it also enables steam

operation.

• Amperometric protector.

This safety device stops the high-pressure cleaner in the event of electrical overcurrent.

If the amperometric protector trips, the warning light (30) will light up. Should this happen, follow

the instructions below:

- turn the main switch (1) to "0" and take the plug out of the mains socket;

- press the cleaner gun lever (24) to discharge any remaining pressure;

- wait 10 to 15 minutes for the high pressure cleaner to cool down;

- check that the requirements for the mains power connections have been followed correctly (see the

INSTRUCTIONS MANUAL – SAFETY INSTRUCTIONS

used;

- reconnect the plug and repeat the start-up procedure described in

• Safety valve.

This duly calibrated maximum pressure valve discharges any excess pressure should an anomaly