Axis Communications Q8665–LE PTZ Network Camera Guide D'installation page 28

AXIS Q8665–LE PTZ Network Camera
Important
• Assemble the product in an upright position. Do not install the product upside down.
• Make sure to connect the pan/tilt unit straight from above as shown in the illustration.
Do not tilt it onto the base unit.
1. Make sure the seal is in position.
2. Tilt the camera housing back.
3. Attach the pan/tilt unit to the base unit and tighten the screws (torque 4 Nm) using the
supplied allen key.
1
Pan/tilt unit
2
Configuration board lid
3
Alignment indicators
4
Seal
28