Witter KA9BU Instructions De Montage

Fitting
Instructions
MATERIALS
A 1 Cross Bar
D 4 M10 x 30 x 1.25mm Bolts, Lock Washers and Flat Washers (20mm O.D.)
E 2 Angle Brackets
F 4 M10 x 40 x 1.25mm Bolts, Lock Washers and Flat Washers (25mm O.D.)
G 4 M10 x 40 x 1.25mm Bolts, Nuts, Lock Washers and 4 Flat Washers (20mm O.D.) and 4 Flat Washers
(25mm O.D.)
H 2 M12 x 100 x 1.75mm Bolts and Nyloc Nuts (Grade 10.9. - Torque setting 139Nm) and 1 Flat Washer
(25mm O.D.)
J 1 Electrical Plate (ZEP2)
FITTING
1. Remove three rearmost exhaust hanger rubbers and support exhaust.
2. Remove towing eye bracket from right hand side chassis rail. Remove existing bolts from underside of chassis rails
one on right hand side and two on left hand side. Remove tape covering mounting points.
3. Loosely attach Angle Brackets (E) to outside face of chassis using Bolts (D). Slide left hand profile over exhaust
hanger and attach to underside of chassis using Bolts (F) and to Angle Brackets (E) using Bolts (G).
4. Loosely attach Centre Strut (ZF) with Spacers (S) and Electrical Plate (J) using Bolts (H). Tighten all bolts. NOTE:
Bolts (H) have a torque setting of 139Nm.
5. Re attach lower edge of bumper.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
GRADE 10.9: M12 – 139Nm
#NAME?
W0001KA9BU-FIT$011003290000
TOWBAR
For Kia Sportage 2
For use with 2031 Series necks
KA9BU
2004 -
Issue 1