Important Safety Instructions; English - Enviracaire HCL-725E Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

Read through all the instructions before starting to use the air condi-
tioner. Keep this manual carefully.
1. Install the air conditioner in a place that is inaccessible to
children.
2. Do not use the air conditioner outdoors.
3. Place the air conditioner upright on a firm, even surface. Make
sure the air conditioner is standing securely so that it cannot fall
over or fall off. Water can damage furniture and floor coverings.
4. Unwind the cable completely. A cable that is not completely
unwound can cause overheating and a fire.
5. Do not use an extension cable or a variable speed controller.
This could cause overheating, fire, or an electric shock.
6. Only plug the air conditioner into a single phase earthed power
socket with the voltage stated on the type plate on the air
conditioner. Make sure that the electric current is adequate where
the air conditioner is in use. The air conditioner must be installed
in accordance with the local safety regulations.
7. Press the power key to the OFF position and always unplug the
air conditioner when it is not in use, or when it is handled,
moved or cleaned. Do not tug at the power cable to unplug the
appliance.
8. Do not point the air discharge vent (3) in the direction of people,
walls, or objects.
9. The air conditioner functions best in the COOL operating mode at
a room temperature of between 15°C and 32°C, and in the DRY
operating mode at a temperature of between 10°C and 35°C.
Either side of those temperature limits there can be operating
faults.
10. Do not operate the air conditioner anywhere near easily
inflammable gases or materials, or near an open fire, or at a
location where oil or water could splash. Make sure that the air
conditioner is not exposed to direct sunshine. Do not use the air
conditioner in a hothouse or near a bathroom, shower, or
swimming pool.
11. Make sure that the air intake vent (4) and air discharge vent (3)
are open before switching on the air conditioner. The air
conditioner must not be located behind curtains or other objects
and obstacles which could interrupt the air circulation. Make sure
that no objects can get into the air intake vent (4) or discharge
vent (3), as this could lead to overheating, fire or an electric shock.
12. Do not unplug the air conditioner while it is operating. First press
the power key (13) to the OFF position.
13. Wait for 3 minutes after switching the air conditioner off, before
switching it on again. The air conditioner has a safety system that
prevents the compressor from being started up again until
3 minutes have elapsed since it was switched off.
14. Do not immerse the air conditioner in water or other liquids and
do not spill water or other liquids onto the air conditioner or into
the air intake (4) and air discharge (3) vents.
15. Clean the air conditioner regularly in compliance with the
cleaning instructions.
16. If the power cable of the air conditioner is damaged, it must be
repaired by a workshop approved by the manufacturer, as
special tools are needed.
17. Always transport the air conditioner in an upright position. If this
is not possible, lay the air conditioner on its side and place it
back in an upright position as soon as you have arrived at your
destination. Wait for at least 60 minutes after transport before
using the air conditioner.
18. Do not use this air conditioner if it is damaged, or shows any
signs of damage, or does not function correctly. Unplug the air
conditioner.

ENGLISH

CONSTRUCTION
2 Display panel
3 Air discharge vent, adjustable
4 Air intake vent (both sides)
5 Air filter (both sides)
6 Tube for emptying the main water tank
7 Tube for emptying the secondary water tank
8 Power cable and plug
9 Cable storage space
10 Castors
11 Transport handles
12 Waste air tube
13 Reducing duct
14 Waste air vent
15 Operating key „ON"/"OFF"
16 Operating mode key
17 Fan speed key
18 Electronic thermostat
19 Control lamp COOL
20 Control lamp fan speed High
21 Control lamp fan speed Low
22 Control lamp DRY and Control lamp water tank
FIRST TIME OF USE
1. Read all the instructions through before starting to use the air
conditioner.
2. Unpack the air conditioner, the power cable and all the
accessories. Remove all packaging materials and dispose of them
in an environmentally friendly manner.
3. Place the air conditioner on a firm, even surface. Make sure it is
standing securely and cannot fall over or fall off. Water can
damage furniture and floor coverings. There must be a safety
distance of at least 50cm between the air conditioner and other
objects. Make sure that the waste air tube (12) is mounted
securely for the COOL operating mode.
EMPTYING THE WATER
Emptying the water out of the main water tank
1. When the main water tank is full, the air conditioner
automatically stops the cooling and drying modes of operation.
The water tank control lamp (22) flashes. The storage capacity of
the water tank allows 4 hours operating time.
2. The water pipe (6) at the back of the air conditioner indicates the
level of water in the main water tank.
3. Switch the air conditioner off and unplug the appliance.
4. Take the water tube (6) completely out of its holder at the back of
the air conditioner. Keep the open end of the water tube closed
while you put it into an external container (e.g. a bucket) with a
capacity of at least 5 liters. Allow the water to run into the
external container. Make sure that the water tube (6) is securely
fixed in the container so that no water can spill. Water can
damage objects and floor coverings and cause an electric shock
(Fig. 7).
5. As soon as all the water has been emptied out of the internal
tank, put the water tube (6) back onto its holder at the back of the
air conditioners. Empty the external container.
Switch the air conditioner back on as described in the „User's
6.
manual".
5