Important - Fracarro SIG7730 Instructions D'emploi

b. From the "Properties" column, select the "Modify" control to associate the program to the chosen
Multicast group (by default, all programs are associated to the same Multicast group – Group 1);
after setting all parameters, confirm them with the SAVE control.
c. Repeat the operation for each program to be sent to the network, making sure to associate a differ-
ent multicast group for each program;
IMPORTANT: for the correct functioning of the module, the 20Mbit/s maximum
through output for each SIG7730 module should not be exceeded (refer to the
MEASURE -> TOTAL BIT RATE menù on the TPE or WEB MANAGEMENT ->
PROGRAM LIST ->TOTAL BIT RATE on the WEB interface menù).
43