Amphenol 151221BF Manuel D'utilisation page 34

Title : Amphenol RET User Guide
Titre : Manuel d'utilisation des RET Amphenol
Reference : User Guide
0x0F Not Configured
0x11 Hardware Error
0x13 Out of Range
0x19 Unknown
Procedure
0x1E Unknown
Parameter
•
The RET has not been configured in production. It has
to be returned
•
The MDCU is not fully inserted into the antenna
•
The Unique Id / Serial Number becomes
« RET_MAINTENANCE00 »
•
The current temperature is out of range
•
The potentiometer is not detected
•
The motor is missing, or the RET cannot detect it.
•
The configuration data file is corrupted
•
The targeted tilt is out of range
•
The read tilt during a motor movement is out of range
•
In response to a Set Device Data, if the new minimum
tilt is lower than the configured minimum tilt
(set by Amphenol)
•
In response to a Set Device Data, if the new maximum
tilt is higher than the configured maximum tilt
(set by Amphenol)
•
The command sent by the BTS is unknown
•
In response to a Set Device Data if the parameter is
unknown.
151221BF
•
Swap the RET/MDCU
•
Return the faulty RET to Amphenol
•
In order to fully insert a RET/MDCU, follow these
steps:
o Disconnect the AISG cable from the
RET/MDCU
o Insert the RET/MDCU into the antenna
o Fasten the screws securing the RET/MDCU
o Connect the AISG cable to the RET/MDCU
•
Change the configuration data file (available on
our website).
o Note: not all BTS equipment offers the
option to change the configuration data
file. In this event, the RET/MDCU needs to
be returned to Amphenol
•
Check the values that have been requested.
•
If the requested values seem to be correct and
within the configured range, swap the RET/MDCU
and return the faulty RET/MDCUto Amphenol
•
Inform the Amphenol R&D
technical.support.ret@amphenol-antennas.com
•
Inform Amphenol R&D
•
technical.support.ret@amphenol-antennas.com
Page 34 sur 69