Haier QDT125SSKSS Instructions D'utilisation page 6

Installation Instructions
STEP 2 ADJUST LEVELING LEGS
• Move the dishwasher close to the installation location and
lay it on its back.
Adjust to
Installation
Height
Figure I
• Measure installation height and dishwasher height.
less than installation height.
STEP 3 REMOVE TOEKICK
Remove
4 Toekick
Screws
Figure J
STEP 4 INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
A B
Remove
Green Dishwasher Wires Are Threaded
Junction Box
Cover
Ground
D
Use UL Listed
Wire Nuts
Figure K
dishwasher white, black (or smooth) to black and ground
appropriate size.
under the cover.
STEP 5 INSTALL 90° ELBOW
°
90
Elbow
Thread
Seal Tape
Figure L
dishwasher.
Check That White, Black and
Thru Hole in Back
White
Black
C
Insert Power
Cord Wires Thru
Strain Relief
and Tighten
Fill
Hose
Water
Valve
Bracket