Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
STEP 16 DISHWASHER WET TEST
Turn on power supply (or plug power cord into outlet,
if equipped).
Start the unit to check for leaks.
cycle illuminates
water does not enter the dishwasher, check to be sure
that water and power are turned on.
turn off power supply, then tighten connections. Restore
power after leak is corrected.
could be caused by door rubbing or hitting against
found, turn power off at the breaker and correct plumbing
as necessary. Restore power after corrections are
Open dishwasher door and make sure most of the water
has drained. If not, check that disposer plug has been
Also check drain line for kinking.
Run the dishwasher through another fill and drain cycle.
to turn unit off.
STEP 17 REPLACE TOEKICK
Use Top 4
Screw Holes
2 - P ie c e T o
Adjust Up
or Down
Figure HH
toekick bracket. The slots should align with toekick
toekick screws.
• Use both toekick pieces for all installation heights.
STEP 18 LITERATURE
• Be sure to leave complete literature package and
Installation Instructions with the consumer.
e k ic k
Publicité
Table des Matières
