Haier QDT125SSKSS Instructions D'utilisation page 7

Installation Instructions
STEP 6 POSITION WATER LINE AND
HOUSE WIRING
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Water
Line
Figure M
STEP 7 INSTALL DRAIN HOSE
THROUGH CABINET
• Stand the dishwasher upright and position in front of the
opening. Insert drain hose into cabinet wall hole. If a power
cord is used, guide the end through a separate hole.
Insulation
Blanket
Figure N
TIP:
avoid interference with base of dishwasher.
4"
6"
House
Wiring
Maximum
Drain Hose
Length 10"
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
STEP 8 SLIDE DISHWASHER
PARTIALLY
INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a time.
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
Figure O
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher is a
• Make sure drain hose is not kinked under the dishwasher
and there is no interference with the water line and wiring
or any other component.