Renkforce 751624 Mode D'emploi page 24

8.2 Connection
1 2 3 4 5
8) Sabotage Contact
Is triggered as soon as the housing cover is lifted.
9) "Door Magnet Contact" Switch
This switch should switch to OFF as soon as door magnet contact is connected to the "door
magnet contact connection" (circuitboard label = REED).
10) "Bypass Tamper" Switch
This switch bypasses 8) Sabotage Contact function.
24
8
10
9
7
6
1) "Lock Out" Relay Contacts
2) "12-24 V (AC/DC)" Connection
3) Alarm Outlet (-)
For connecting an alarm siren. (=nega-tive
switched; circuitboard label = "AL OUT(-)")
4) "Egress" Connection (P.B.)
An NO sensor can be attached here which
can activate the "Lock Out" relay contacts.
5) "Door Magnet Contact" Connection
For connecting a door magnet contact
NC). Circuitboard label = REED
6) "Aux Out" Relay Contacts
7) "Reset" Switch
For resetting the lock to factory settings
(see chapter "9.8 Restore factory settings
(RESET)").