Porter Cable Universal Fitment PCC710 Manuel D'instructions page 8

This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is
a normal condition, and does not indicate a problem. To facilitate the cooling of the
battery pack after use, avoid placing the charger or battery pack in a warm environment
such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on
jobs which were easily done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
INSTALLING/REMOVING ThE BATTERY PACk FROM ThE TOOL
CAUTION
:
Do not hold or contact the accessory when inserting or removing the
battery pack or turning the unit on.
CAUTION
:
Make sure the switch is off when the tool is not being used.
TO INSTALL BATTERY PACk: Insert battery pack (E) firmly into tool until an audible
click is heard as shown in Figure 3.
TO REMOVE BATTERY PACk: Depress the battery release button (F) as shown in
Figure 4 and pull battery pack out of tool.
Detail Sanding
Sanding in extremely tight areas otherwise difficult to reach and require hand sanding. Select a
high oscillating frequency. Sand with continuous motion and light pressure. Applying excessive
pressure does not increase material removal; but will prematurely wear sanding sheets.
Flush Cutting
Remove excess wood from door jamb, window sill and/or toe kick. Removing excess
copper or PVC pipe.
Removal Work
Carpets & backing, old tile adhesives, caulking on masonry, wood and other surfaces.
Removal of Excess Materials
Tile grout, plaster, mortar splatters, concrete on tiles, sills.
Preparation of Surfaces
New floors and tiles.
A.) On/Off switch B.) Variable speed dial
D.) Tool-Free accessory clamp
This product uses the batteries and chargers listed below.
20V Max* Lithium-Ion Batteries: PCC680L, PCC685L
20V Max* Lithium-Ion Chargers: PCC690L, PCC691L, PCC695L
The PCC710 features an exclusive Tool Free System for faster accessory changes and
adjustments without the need for wrenches or hex keys like other oscillating tool systems.
• Grasp the tool and squeeze the Tool-Free System's accessory clamping lever as
shown in figure 4.
• Clean any residual debris from the tool shaft and the accessory holder.
INTENDED USE
COMPONENTS
INSTALLING/REMOVING ACCESSORIES
C.) LED Light
E.) Battery (not included)
8