Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
contaminated paint particles. Workers should wash and clean up BEFORE eating, drinking
or smoking. Articles of food, drink, or smoking should not be left in the work area where dust
would settle on them.
ENVIRONMENTAL SAFETY
1. Paint should be removed in such a manner as to minimize the amount of dust generated.
2. Areas where paint removal is occurring should be sealed with plastic sheeting of 4 mils thickness.
3. Sanding should be done in a manner to reduce tracking of paint dust outside the work area.
CLEANING AND DISPOSAL
1. All surfaces in the work area should be vacuumed and thoroughly cleaned daily for the
duration of the sanding project. Vacuum filter bags should be changed frequently.
2. Plastic drop cloths should be gathered up and disposed of along with any dust chips or
other removal debris. They should be placed in sealed refuse receptacles and disposed of
through regular trash pick-up procedures. During clean up, children and pregnant women
should be kept away from the immediate work area.
3. All toys, washable furniture and utensils used by children should be washed thoroughly
before being used again.
Symbols
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................volts
Hz ................hertz
min ..............minutes
or DC ...direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
............Read instruction manual before use
................Use proper eye protection
• When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The table shows the correct size to use depending on
cord length and nameplate ampere rating. If in doubt, use the next heavier gauge. The
smaller the gauge number, the heavier the cord.
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25 ft.
7.6 m
15.2 m
Wire Size AWG
18
Important Safety Instructions for Battery Chargers
SAVE ThESE INSTRUCTIONS: This manual contains important safety instructions for battery chargers.
WARNING:
charger, battery pack, and product using battery pack.
• Shock hazard. Do not allow any liquid to get inside charger.
• Burn hazard. To reduce the risk of injury, charge only designated PORTER-CABLE
batteries. Other types of batteries may burst causing personal injury and damage.
• Under certain conditions, with the charger plugged in to the power supply, the charger
can be shorted by foreign material. Foreign materials of a conductive nature such as,
but not limited to, steel wool, aluminum foil, or any buildup of metallic particles should
be kept away from charger cavities. Always unplug the charger from the power supply
50 ft.
75 ft.
22.9 m
18
16
SAVE ThESE INSTRUCTIONS
Before using charger, read all instructions and cautionary markings on
A ...................amperes
W ..................watts
or AC ......alternating current
n o .................no load speed
.................earthing terminal
................safety alert symbol
opm ...............oscillations per minute
.................Use proper respiratory protection
.................Use proper hearing protection
100 ft.
125 ft.
30.5 m
38.1 m
16
14
5
150 ft.
175 ft.
45.7 m
53.3 m
14
12
Publicité
Table des Matières
