Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our service website
at www.portercable.com. You can also order parts from your nearest PORTER-CABLE Factory
Service Center or PORTER-CABLE Authorized Warranty Service Center. Or, you can call our
Customer Care Center at (888) 848-5175.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information
about PORTER-CABLE, its factory service centers or authorized warranty service centers,
visit our website at www.portercable.com or call our Customer Care Center at (888)
848-5175. All repairs made by our service centers are fully guaranteed against defective
material and workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North,
Jackson, Tennessee 38305, (888) 848-5175 - Attention: Product Service. Be sure to
include all of the information shown on the nameplate of your tool (model number, type,
serial number, etc.).
ACCESSORIES
WARNING:
have not been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only PORTER-CABLE recommended
accessories should be used with this product.
A complete line of accessories is available from your PORTER-CABLE Factory Service
Center or a PORTER-CABLE Authorized Warranty Service Center. Please visit our
Web Site www.portercable.com for a catalog or for the name of your nearest supplier.
NOTE:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
Problem
• Unit will not start.
• Unit starts immediately
upon inserting battery.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
• Unit shuts off abruptly.
For assistance with your product, visit our website at www.portercable.com for a list of
service centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.
Since accessories, other than those offered by PORTER-CABLE,
TROUBLEShOOTING
Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• The switch has been
left in the "on" position.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
• Battery pack has reached its
maximum thermal limit.
• Out of charge. ( To
maximize the life of the
battery pack it is designed
to shutoff abruptly when
the charge is depleted.)
Possible Solution
12
• Check battery pack
installation.
• Check battery pack
charging requirements.
• The switch must be moved
to "off" to prevent the tool
from immediately starting
when battery is inserted
charger until LED lights.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
• Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
• Allow battery pack to cool
down.
• Place on charger and
allow to charge.
Publicité
Table des Matières
