Lubrication - Hoover MPWR 40V Guide D'utilisation

Filters
WARNING:
OR SERVICING. DO NOT OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.
HEXAGUARD ACTIVATED
™
CARBON FILTER
1
The HexaGuard
™
located on the inside of the filter
door. Pull to remove.
IMPORTANT:
EDGE SO AIR CIRCULATES ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
REPLACEMENT
FILTER
Replace HexaGuard
Filter yearly for optimum
performance.
Part No. 440009176

LUBRICATION

The motor is equipped with bearings which contain sufficient lubrication for its lifetime.
The addition of lubrication could cause damage. Do not add lubrication to motor.
TO REDUCE THE RISK OF PERSONAL INJURY – REMOVE BATTERY BEFORE CLEANING
Filters are
™
INLET FILTER
The inlet filter is located on the inside,
bottom of bag housing and protects
the motor from damage.
1
If the filter becomes dirty, pull
off the grill and lift out the filter.
Hand rinse in cold water under
low pressure. Let filter dry for 24
hours. Reposition dry filter and
snap grill into place.
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON
REPLACEMENT
FILTER
Inspect Inlet Filter every
2 weeks to keep vacuum
running at peak performance.
Part No. 440009175
17